Training Sessions

Back to Education

Thursday, October 5th, 2017  

9:00 AM – 11:00 AM

EDX Wireless Network Design, Deployment and Optimization Training  

Room: Cactus

Instructor: Roger Skidmore, EDX Wireless

While wireless communication networks and the service areas in which they are deployed continue to evolve, the solutions used to design these networks must be apt to address these challenges.  EDX SignalPro has been supporting engineers since 1985 by offering a comprehensive, all-in-one solution for the planning, deploying and optimizing of wireless networks.  With support for systems from 30MHz up to 100GHz, EDX software is used for designing LTE, Mesh, DAS, Multipoint, Microwave, SCADA, LMR and more.  Our training session will cover basic setup and use of SignalPro, providing attendees with an understanding of how to utilize the software in their application and ensure wireless networks are meeting performance and budgetary requirements.

Training Objectives:

The proper planning of a wireless network pre-deployment.

Building a 3D Model of service areas using high-resolution data.

Optimizing networks and modeling various scenarios for performance efficiency.

  

Cambium Networks LINKPlanner Training

 

Room: Thistle

Instructor: Dave Geitner, Cambium Networks

With LINKPlanner, one can quickly design networks for optimal deployment and cost effectiveness with ease.

Training Objectives:

Learn how LINKPlanner allows you to model “what if” scenarios to optimize system performance before purchase.

Learn how to quickly design networks for optimal deployment and cost effectiveness with ease.

Learn how to use LINKPlanner.

Course Requirements: Attendees must bring their own laptop computers for this training.

 

12:30 PM – 4:30 PM

JMA Basic Connector Training

 

Room: Thistle

Instructor: Scott Leyland, JMA Wireless

Certification training for JMA Connectors with hands on installation

Training Objectives:

Basic of coaxial cable types and measure.

Understanding of testing methodology and basic troubleshooting.

Proper installation and testing of antenna line systems and proficiency with installation of JMA compression connectors.

 

Spectrum Analyzers and Cable Testing

Room: Cactus

Instructor: Steve Benson, End 2 End Network Solutions

Learn how to use modern spectrum analyzers for FCC compliance and interference detection. How the spectrum analyzer works and how to interpret what it shows. Find out how to test coax cables and antennas with a tracking generator. Learn how to use new features for cable analysis such as the Distance to Fault function and how to interpret what it is telling you about your cable.

 

Event Sponsor: